Waterproof DS18B20 Digital Thermal Probe or Sensor

This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC so we suggest keeping it under 100°C. Because they are digital, you don’t get any signal degradation even over long distances! These 1-wire digital temperature sensors are fairly precise (±0.5°C over much of the range) and can give up to 12 bits of precision from the onboard digital-to-analog converter. They work great with any microcontroller using a single digital pin, and you can even connect multiple ones to the same pin, each one has a unique 64-bit ID burned in at the factory to differentiate them. Usable with 3.0-5.0V systems

Not for use in salt water or other corrosive environments.

Cable Features :

1. Stainless steel tube 6mm diameter by 30mm long
2. Cable is 36″ long / 91cm, 4mm diameter
3. Contains DS18B20 temperature sensor
4. If your sensor has four wires – Red connects to 3-5V, Black connects to ground and White is data. The copper wire is soldered to the wire shielding
5. If your sensor has three wires – Red connects to 3-5V, Blue/Black connects to ground and Yellow/White is data

DS18B20 Technical specs:

1. Usable temperature range: -55 to 125°C (-67°F to +257°F)
2. 9 to 12 bit selectable resolution
3. Opto isolation circuitry
4. Uses 1-Wire interface- requires only one digital pin for communication
5. Unique 64 bit ID burned into chip
6. Multiple sensors can share one pin
7. ±0.5°C Accuracy from -10°C to +85°C
8. Temperature-limit alarm system
9. Query time is less than 750ms
10. Usable with 3.0V to 5.5V power/data

Documentation:

1. Datasheet

Package Includes :

1 x 2 Channel isolated 5V 10A relay module with Optocoupler